repository
Design of Antennas and Feed Networks for Millimeter-Wave Applications
- Alternative Title
- Sangwook Park
- Author(s)
- 박상욱
- Alternative Author(s)
- Sangwook Park
- Advisor
- 감동근
- Department
- 일반대학원 전자공학과
- Publisher
- The Graduate School, Ajou University
- Publication Year
- 2018-08
- Language
- eng
- Keyword
- 77-GHz radar frontend module; aperture coupled patch antenna; feed network; fifth-generation; millimeter-wave
- Alternative Abstract
- As demand for mobile and fixed communication systems increases, various studies are underway to use millimeter-wave (mmWave) bandwidths that are higher than the frequencies used in the past. Fifth-generation (5G) mobile communication using the 28-GHz band and Wireless Gigabit Alliance (WiGig) using the 60-GHz band are typical examples. Millimeter-waves with good resolution are also suitable for use in automotive radar for improving driver safety and convenience, and imaging systems for security and medical. As the antenna is one of the key components in these mmWave applications, antenna design is required for each application. The feed network design is also one of the key technologies since the discontinuity of the feed network directly affects the performance of the antenna. In this dissertation, I designed mmWave antennas and feed networks connected from the monolithic microwave integrated circuit (MMIC) to the antenna. Designing antennas and feed networks in that band must be entirely dependent on electromagnetic simulations. Therefore, I proposed the procedure of validation of modeling and simulation for efficient and accurate simulation and preceded studies to verify it using several examples. Three simulators which are mainly used to analyze the three-dimensional (3D) electromagnetic (EM) model are utilized and the results were applied to design antennas and feed networks. Next, antennas for use in 5G mobile devices were proposed and experimentally verified. The double-sided flexible printed circuit (FPC) was folded to realize an aperture-coupled patch antenna, which reduces the cost of the process required for stacking. In addition, the feed line and the patch of the antenna were folded by 90° so that the antenna radiates in the end-fire direction. The above design method satisfied the low-cost, miniaturization and end-fire radiation. In addition, the performance was improved by adjusting the spacing between the radiation patch and the aperture at no additional cost. Finally, I designed the feed networks connected from the MMIC to the antenna. Since the 28-GHz MMIC cannot be obtained, it was replaced with the MMIC and antenna used in the automotive radar front-end module in the same mmWave band. The stack-up and the dielectric properties of the module to be designed were determined. Based on this, I designed transition structures to compensate the discontinuity and to measure the fabricated feed networks. A 9-channel jig was designed to measure multiple channels simultaneously. Designed feed networks were verified through both simulation and measurement.
- Fulltext
- Appears in Collections:
- Graduate School of Ajou University > Department of Electronic Engineering > 4. Theses(Ph.D)
- Files in This Item:
- There are no files associated with this item.
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.
-
- License
- STATISTICS
- Total Visit :3,347,963
- Total Download :1,746
- Today View :2,123
